51 21 300 Removing and installing or replacing window cavity cover strip on outside of left or right front door
Special tools required:
- 00 9 324
- 00 9 325
IMPORTANT:
Weather strip in plastic design cannot be removed without damage.
Observe PROCEDURE for using special tool 00 9 324.
Refer to: THE "INSTRUCTIONS ON FITTING WINDOW GUIDE SEALS" SERVE AS THE BASIS FOR THIS REPAIR instructions and must be observed without fail.
Observe PROCEDURE for using special tool 00 9 324.
Refer to: THE "INSTRUCTIONS ON FITTING WINDOW GUIDE SEALS" SERVE AS THE BASIS FOR THIS REPAIR instructions and must be observed without fail.
Necessary preliminary tasks:
- Remove the MIRROR ON FRONT DOOR
IMPORTANT:
If reusing the existing window cavity cover strip (1), make sure it is not bent.
Lever out weather strip (1) with special tool 00 9 324 (starting at B-pillar).
At the same time, pry out weather strip (1) carefully using special tool 00 9 325 in the area of the B-pillar cover.
Installation note:
Moisten weather strip (1) prior to installation with APPROVED LUBRICANT .