33 55 000 Removing and installing/replacing rear anti-roll bar
Necessary preliminary work:
- Undo ANTI-ROLL BAR LINKS AT THE ANTI-ROLL BAR .
- Lower REAR AXLE SUPPORT .
Release screw (1). (Left side only.)
Tightening torque 33 32 6AZ.
Installation note:
Replace screw.
TIGHTEN DOWN SCREW CONNECTION IN NORMAL POSITION .
NOTE:
To simplify the illustration, anti-roll bar removal is shown on the removed rear axle.
Release screws (1).
Tightening torque 33 55 1AZ .
Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR .
Turn anti-roll bar (2) and remove toward the left side.
Installation note:
Check both rubber mounts for damage and replace if necessary.