33 41... Detaching wheel bearing inner ring from drive flange (drive flange removed)

Special tools required: 

• 33 4 409
• 33 4 407
• 33 4 401
• 33 4 403
• 33 4 404
• 33 4 402
• 33 4 400

Insert pliers 33 4 407 into special tool 33 4 401.

Courtesy of BMW OF NORTH AMERICA, INC.

Position special tool 33 4 401 in conjunction with 33 4 407 on drive flange.

Courtesy of BMW OF NORTH AMERICA, INC.

Pull special tool 33 4 401 together with rings 33 4 403 and 33 4 404 until the pliers 33 4 407 are fitted flush in the groove between the drive flange and wheel bearing inner ring.

Unscrew spindle 33 4 402 as far as is possible.

Courtesy of BMW OF NORTH AMERICA, INC.

Use special tool, see BMW Workshop Catalogue. 

• Hydraulic unit - 81 64 2 155 744
• Adapter kit 1 - 81 64 2 155 745
• Adapter kit 2 - 81 64 2 155 746

The following work steps describe pulling off the wheel bearing inner ring: 

Courtesy of BMW OF NORTH AMERICA, INC.

• Pressure cylinder of hydraulic unit (1) must be in the initial position.
• Spindle F3 must terminate flush with hydraulic unit (1).
• Assemble special tool, see illustration.
• Turn spindle of special tool 33 4 400 up to limit position.

The following tools are required for detachment, consult illustration for arrangement:

Vehicle components: 

I	Drive flange hub
II	Wheel bearing inner ring

Required components for all models and types: 

F3	Spindle M24 (length 270 mm)
1	Hydraulic unit
E3	Washer M24
C1	Holding sleeve
B1	Adapter
33 4 400	Special tool

* Components specific to model and type: 

K2	Screws M14 x 1.5