34 32 980 Replacing rear left or right brake hose
NOTE:
After completing repair work:BLEED BRAKE SYSTEM WITH DSC .
- Read and comply with GENERAL INFORMATION.
- Remove the WHEEL .
After completing repair work:BLEED BRAKE SYSTEM WITH DSC .
Press brake pedal down to floor and secure with pedal support.
NOTE:
The pedal support may only be released when the brake lines are reconnected.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
IMPORTANT:
Grip brake hose at square head (2) so that connecting piece cannot rotate in retaining bracket.
Never twist brake hose when installing it and avoid all contact with parts attached rigidly to the body.
Never twist brake hose when installing it and avoid all contact with parts attached rigidly to the body.
Disconnect brake hose from brake line (1).
Installation note:
Tightening torque, refer to: 34 32 1AZ.
Detach brake hose from brake caliper (3).
Installation note:
Tightening torque, refer to: 34 32 3AZ.
Installation note:
First tighten brake hose on brake caliper.
Insert brake hose in bracket and screw onto brake pipe.