52 26 012 Removing and installing/replacing backrest for right rear seat
Necessary preliminary tasks:
- Remove the ARMREST SIDE SECTION
- Unclip the REAR SEAT and lay down towards front
Release screw (1).
Installation note:
Replace screw (1).
Tightening torque, refer to: 52 26 01AZ.
- Tilt backrest slightly forwards.
- Pull backrest forwards and outwards out of center mount
Installation note:
The plastic bush (1) may slide during removal of the right backrest.
Make sure plastic bush (1) is fitted correctly in the right backrest frame.
The plastic bush (1) must be retained in the backrest frame.
If applicable, clip the plastic bush (1) in from the outside in.