51 23... Adjusting/replacing bump stops (rear)

The graphics are schematic representations and are to be applied to the relevant vehicle type.

Prerequisite: Lid must be correctly adjusted.

Following parts must not be damaged:

• (1) Bump stop
• (2) Catches

Remove stop pad by pressing detents back.

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in stop pad (1) to create distance to front compartment lid.

Place a cone (2) of modeling or sealing compound on the stop pad.

Slowly close the hood.

Courtesy of BMW OF NORTH AMERICA, INC.

Raise the hood.

Compressed cone (1) determines distance between stop pad and front compartment lid.

Courtesy of BMW OF NORTH AMERICA, INC.

Measure dimension a between compressed cone and edge (1) of stop pad.

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust measured dimension a + 0.5 mm by unscrewing stop pad (1).

Courtesy of BMW OF NORTH AMERICA, INC.