63 14 060 Removing and installing/replacing the front left or right side marker

Special tools required:

009325

Necessary preliminary tasks:

Refer to: PARTIALLY REMOVE FRONT WHEEL ARCH COVER (front section)

NOTE: Minimum object temperature of side marker and bumper panel ≥ 18°C.
If this temperature is not achieved, the components must be preheated.

Remove side marker:

Carefully preheat side marker (1) in area (3) using hot air blower and use special tool 00 9 325 to release it from the bumper panel (2).

NOTE: The side marker (1) cannot be used again.

Courtesy of BMW OF NORTH AMERICA, INC.

Clean bumper panel:

To clean use a lint-free disposable cloth or a clean cleaning cloth.

Clean bonding surface of bumper panel using spirits.

Air drying time at least 1 minute.

Do not grip bonding surface.

Install side marker:

Release liner* (1) and lightly press side marker (2) to bumper panel.

Check position and realign, if necessary.

The minimum contact pressure is achieved by firmly pressing your thumbs or the balls of your hands over the entire joining area (holding time approx 1 second).

Firm thumb pressure approx. 35 N/cm2.

* Liner is protective film at new side marker.

Courtesy of BMW OF NORTH AMERICA, INC.