61 36 605 Removing and installing/replacing relay for fan control

Necessary preliminary tasks: 

• Clamp off BATTERY LEAD FROM NEGATIVE CONNECTION POINT 

Turn locks (1) 90° counterclockwise.

Unlock catch (3).

Remove cover (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanism (arrow) and pull relay carrier (1) up and out of power distribution box (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanism (1) from relay carrier (2) and pull relay (3) off of relay carrier (2).

Installation note: 

Ensure that relay carrier (2) and relay (3) are properly engaged.

Courtesy of BMW OF NORTH AMERICA, INC.

For hot-climate version: 

Unfasten plug connection (1) and disconnect.

Release nuts (2) and attach cable to the side.

Tightening torque, refer to: 61 21 1AZ .

Loosen screws on relay (3) and remove relay.

Tightening torque, refer to: 61 36 1AZ .

Installation note: 

Ensure that cable (2) and relay (3) are screwed on properly.

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks: 

• Remove the COWL PANEL COVER
• Clamp off BATTERY LEAD FROM NEGATIVE CONNECTION POINT 

Release screws (1).

Remove attachment part of partition wall (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanism (1) and pull off intake port (2) towards top.

Courtesy of BMW OF NORTH AMERICA, INC.

Remove latch mechanism (1) from the relay carrier.

Pull off the relay (2) upwards from the relay carrier.

Courtesy of BMW OF NORTH AMERICA, INC.