REP-TAT-P-1353-02 Installing fuel delivery line
- Slide the fuel supply line in the direction of the arrow into the snap fastener (2) and lock.
The fuel supply line must be audibly engage in the snap fastener (2).
- Secure the clamp (1).
- Tighten down screw (3).TIGHTENING TORQUES SPECIFICATION
Fuel line to cylinder head cover 6x18 tightening torque 7 Nm - Guide the fuel delivery line (2) in and install.
- Install rubber damper (3).
- Make sure the rubber damper (3) is fitted correct.
- Tighten the union nut (1) hand-tight.
- Tighten union nut (1).TIGHTENING TORQUES SPECIFICATION
Feed line to high pressure pump M14X1.5
If 34 Nm is exceeded, replace the feed line.31 Nm - Check fuel system for leak tightness.