REP-TAT-P-1161-02 Installing the intake plenum
- Replace gaskets (1).
Parts: Seals
NOTE:
Additional coolant can leakage. Make sure that no coolant enters the intake port of the cylinder head.
- Position the intake plenum.
- Tighten screws in the order (1) to (7).
Tightening torques
| Intake plenum to cylinder head | ||
|---|---|---|
| Observe tightening sequence. | Joining torque | 5 Nm |
| tightening torque | 10 Nm | |
- Tighten down screws (8).
TIGHTENING TORQUES SPECIFICATION
| Intake plenum to rear/front support | |
|---|---|
| BM6 x 25 | 10 Nm |
NOTE:
Make sure that the connections are locked correctly The locks must engage audibly.
- Lock the closure (2) and connect the coolant return line.
- Lock the closure (1) and connect the coolant feed line.
- Clip the wiring harness into the clamp (3).
- Clip in wiring harness in marked areas.
- Connect the connector (1) to the boost pressure sensor.
NOTE:
Make sure that the connections are locked correctly. The locks must engage audibly.
- Lock closure (2) and connect to the coolant pipe.
- Attach the tank vent line (1) in the signaled area.
- Clip in cable (6) in marked areas.
- Position the engine wiring harness and tighten with the screws (5).
TIGHTENING TORQUES SPECIFICATION
| Wiring harness to intake plenum |
|---|
| 5 Nm |
- Position tank vent line (4).
- Tighten the screw (3) and clip in the tank vent line (4) in the marked area.
TIGHTENING TORQUES SPECIFICATION
| Tank vent line to intake plenum | |
|---|---|
| TS5 x 16 | 5 Nm |
- Connect the engine ventilation line (2) to the intake plenum.
- Clip in the tank vent line (1) in the marked area.