REP-TAT-P-1137-02 Installing all gates

• Have the special tool 2 359 089  ready.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clean contact surfaces 1  and 2  off oil, grease and dirt.

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the gate 2  and hand-tighten the screw 1  .
• Make sure the intermediate lever 3  is in the correct installation position.

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the special tool 2 359 089  on the cylinder head.
• Pre-tension the gate with the lever 3  .
• Abut the screw 1  in the area 2  .
• Make sure that the special tool 2 359 089  does not rotate during this process.

Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the gate with the lever 1  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Ensure that the special tool 2 359 089  lies flat on the cylinder head.

Courtesy of BMW OF NORTH AMERICA, INC.

• Press the special tool 2 359 089  onto the cylinder head.
• Tighten the screw 1  at the same time.

Courtesy of BMW OF NORTH AMERICA, INC.

• Check the conventional gauge 1  in area A  for correct gap dimension.

Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the gate 1  lies correctly against the bearing bracket 2  .

The gate 1  is correctly installed in the marked area.

Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the gate 1  lies correctly against the bearing bracket 2  .

The gate 1  is not correctly installed in the marked area.

Courtesy of BMW OF NORTH AMERICA, INC.

• Repeat the procedure for all gates.