REP-TAT-P-1800-02 Install exhaust system
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
CAUTION:
Component with heavy weight.
Injury hazard!
Injury hazard!
- Note component's center of gravity.
- Support component using a jack.
- Secure component against falling off the jack.
- Open the weld seam (1) with a conventional tool.
- Remove ribbon clamp (2).
- Replace the (1) ribbon clamp.
Parts : Ribbon cable clamp
- Install the exhaust system with a second person.
- Connect exhaust-system to the catalytic converter.
- Tighten clamp (1).TIGHTENING TORQUES SPECIFICATION
Exhaust System To Catalytic Converter Ribbon clamp nut M8
Replace the ribbon clamp.tightening torque 26 Nm Ribbon clamp nut M10
Replace the ribbon clamp.tightening torque 55 Nm - Replace nut (2).
Parts : Nut
- Tighten nut (2).TIGHTENING TORQUES SPECIFICATION
Front Silencer/Gasoline Particulate Filter On Transmission Holder M8
Replace nut.tightening torque 19 Nm - Connect the connector (1), it should lock audibly.
- Replace nuts (2).
Parts : Nuts
- Tighten nuts (2).TIGHTENING TORQUES SPECIFICATION
Rear Silencer To Body/Bumper Support M8
Replace nuts.tightening torque 19 Nm