REP-TAT-P-1165-02 Installing the trim strip for the exhaust turbocharger

• Replace the highlighted screws.

  Parts  : screw

• Position the trim strip (1).
• Tighten the highlighted screws from the inside towards the outside.

TIGHTENING TORQUES SPECIFICATION

Trim strip at the cylinder head
M7 x 27 Replace screws. Tighten from the inside to the outside.	1. Assembly torque	10 Nm
	2. Assembly torque	16 Nm
	3. Final torque	16 Nm

Courtesy of BMW OF NORTH AMERICA, INC.