11 00 670 Securing engine in installation position: Notes

Preliminary work 

• Refer to DISCONNECTING ALL BATTERY GROUND LEADS
• Refer to REMOVING THE ACOUSTIC COVER 
• Refer to UNINSTALLING COVER FOR THE DME CONTROL UNIT
• Refer to DISCONNECTING THE CONNECTOR FROM THE DME CONTROL UNIT AND FROM THE POWER DISTRIBUTION MODULE (PDM)
• Refer to REMOVING THE DME CONTROL UNIT
• Refer to REMOVING THE INTEGRATED POWER SUPPLY MODULE (PDM)
• Refer to REMOVING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
• Remove the cover in the left engine compartment
• Remove the right cover in the engine compartment
• Remove the sound insulation on the bulkhead upper part at the center

Follow-up work 

• Lower the engine and detach the engine bridge
• Install the sound insulation on the bulkhead upper part at the center
• Install the cover in the engine compartment on the left
• Install the cover in the engine compartment on the right
• Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
• Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM)
• Refer to INSTALLING THE DME CONTROL UNIT
• Refer to CONNECTING THE CONNECTOR TO THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM)
• Refer to INSTALLING COVER FOR THE DME CONTROL UNIT
• Refer to INSTALLING ACOUSTIC COVER 
• Refer to CONNECTING ALL BATTERY GROUND LEADS
• Take hood out of the service position