32 21 151 Replacing left or right track rod end

NOTE: If the track rod end to track rod screw connection is released, it is necessary after reinstallation to carry out a wheel alignment check.

Necessary preliminary work:

IMPORTANT: Do not release track rod end from swivel bearing with impact tool.
Rubber boot of track rod end must not be damaged!

Release nut (1), if necessary, grip at inner Torx socket.

Remove track rod end (2) from swivel bearing.

Installation note:

Keep track rod end to swivel bearing connection clean and free from oil and grease.

Replace self-locking nut.

Tightening torque, refer to: 32 21 3AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Determine dimension (A) to simplify following adjustment of front axle.

Slacken bolt (1).

Screw off track rod end; if necessary, grip track rod with open-end spanner.

Installation note:

Check the GAITER for damage, replace if necessary.

Screw track rod end onto track rod to dimension (A).

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque, refer to: 32 21 2AZ .

After installation: