65 77 755 Removing and installing (replacing) front passenger seat sensor

WARNING: Note INSTRUCTIONS ON AIRBAG SAFETY REGULATIONS!
Failure to observe correct procedures can deploy the airbag and cause injuries.

Preliminary work needed:

Unlock connector housing (1 to 3) and pull out of connector housing (4) in arrow direction.

Installation note:

Connectors are encoded against incorrect assembly.

Make sure installation sequence of connector housing (1 to 3) is correct.

Courtesy of BMW OF NORTH AMERICA, INC.

Remove screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Release detent (1) in marked area.

Remove sensor (2).

Installation note:

Make sure sensor (2) is correctly fitted.

Courtesy of BMW OF NORTH AMERICA, INC.