72 11 033 Removing and installing/replacing front left or right seat belt
Necessary preliminary work:
- Remove the PANEL FOR DOOR POST
For electrical front seat version:
Move backrest to full rearward position.
Grip end fitting cover centrally between seat belt strap and cover.
Unclip end fitting trim in direction of arrow.
Installation note:
Install end fitting cover as follows:
- Insert cover with rear guide in covering.
- Insert cover in direction of arrow downwards in covering
- Engage top left of cover in covering.
For manual front seat version:
Move backrest to full rearward position.
Grip end fitting cover in marked area between cushion and cover.
Unclip the end fitting trim in direction of arrow (1).
Feed out end fitting cover (2) in direction
Installation note:
Install end fitting cover as follows:
- Insert cover with front guide in cover
- Insert cover in direction of arrow downwards in covering
- Engage top cover in marked area in covering.
Release screw (1).
Installation note:
Replace screw (1).
Tightening torque, refer to: 72 11 2AZ .
Remove end fitting.
Installation note:
End fitting is coded against incorrect assembly.
Release screws (1).
Tightening torque, refer to: 72 11 4AZ .
Remove slide bar (2).
Release screw (3).
Installation note:
Replace screw (3).
Tightening torque, refer to: 72 11 3AZ .
Put seat belt guide loop with seat belt (4) away.
Basic version of seat belt:
Release screw (1).
Installation note:
Replace screw (1).
Tightening torque, refer to: 72 11 1AZ
Remove inertia reel mechanism (3).
Installation note:
The encoding (2) of the automatic reel must be positioned in the body recess.
US version only:
Unlock plug connection (4) and disconnect.
Release screw (1).
Installation note:
Replace screw (1).
Tightening torque, refer to: 72 11 1AZ .
Remove inertia reel mechanism (3).
Installation note:
The encoding (2) of the automatic reel must be positioned in the body recess.
Version REMA* seat belt/SA5AL Active Protection:
*REMA = reversible electromotive inertia reel
REMA seat belt can be identified through the two attachment points (2).
Unfasten plug connection (1) and disconnect.
Unfasten screws (2).
Installation note:
Replace screws (2).
Tightening torque, refer to: 72 11 1AZ .
Remove automatic reel (3) and detach remaining plug connection.
Installation note:
The encoding (4) of the automatic reel (3) must be positioned in the body recess.
During replacement with version REMA seat belt/SA5AL Active Protection:
Carry out PROGRAMMING/ENCODING .
Installation note:
Carry out FUNCTION CHECK .