12 14 523 Replacing pulse sensor on intake camshaft (B48)

Attention! 

Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)!

Necessary preliminary tasks: 

• Remove the ACOUSTIC COVER

Removal: 

Unlock and disconnect plugs (1).

Release screw (2).

Remove pulse generator (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation for installation: 

Check gaskets (1).

Replace damaged gasket (1).

Parts: Gaskets. 

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Install pulse sensor (3).

Tighten screw (2).

Tightening torque, refer to: 13 62 1AZ .

Attach and lock connector (1).

Connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install the ACOUSTIC COVER .