11 41 115 Installing and removing/replacing hydraulic valve for oil pressure control (B48B)

Necessary preliminary work:

Removal:

Release engine encapsulation (1) in area of hydraulic valves.

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew transmission bolt (1) by a few turns.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect the connector (1).

Release screw (2).

Unscrew the transmission bolt until the hydraulic valve can be removed.

Courtesy of BMW OF NORTH AMERICA, INC.

Remove hydraulic valve (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Parts: Replace O-ring (1).

Oil O-ring (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Install hydraulic valve (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screw (2).

Tightening torque: 11 41 6AZ .

Connect the connector (1).

Tighten the transmission bolt.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the transmission bolt (1).

Tightening torque: 24 00 1AZ .

Tightening torque: 23 00 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Relocate engine encapsulation (1) correctly.

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking: