33 55 000 Removing and installing/replacing rear anti-roll bar

Necessary preliminary work: 

• Undo the ANTI-ROLL BAR LINKS AT THE ANTI-ROLL BAR .
• Lower the REAR AXLE SUPPORT .

Release screw (1). (Left side only.)

Tightening torque, refer to: 33 32 6AZ.

Installation note: 

Replace screw.

Tighten down SCREW CONNECTION IN NORMAL POSITION.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque, refer to: 33 55 1AZ

Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR .

Turn anti-roll bar (2) and remove toward the left side.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Check both rubber mounts for damage and replace if necessary.