41 34 041 Stripping Operations - Replacing Tail Panel
NOTE:
Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.
The following list basically represents the removal sequence.
- Remove battery (FR number: 61 21 010)
- Remove bumper trim (FR number: 51 121 56)
- Remove bumper carrier (FR number: 51 12 050)
- Remove guide for rear bumper in the center (job number: 51 12 825)
- Remove guide for rear left and right bumper (job number: 51 12 828)
- Remove both rear lights (job number: 63 21 180)
- Remove luggage compartment floor trim panel
- Upper tail panel trim (FR number: 51 46 050)
- Remove and install tailgate striker (FR number: 51 24 130)
- Remove left luggage compartment wheel arch panel (FR number: 51 47 151)
- Remove right luggage compartment wheel arch panel (FR number: 51 47 161)
- Lower rear silencer
- Remove heat shields
- Partially detach tailgate seal
Release latch mechanisms and remove rear ventilation (1).
Partially release insulating mat (2) and tie to one side.
Installation Note:
The rear ventilation must not be damaged! (watertightness).
All latch mechanisms must engage audibly.
Undo nut (1) and remove the negative battery cable (2).
Tightening torque: refer to BATTERY WITH TERMINAL .
Release latch mechanisms and remove rear ventilation (3).
Partially release the insulating mat (4) and tie to one side.