51 46 011 Removing and installing (replacing) trim panel for storage shelf (version with through-loading system)

Necessary preliminary work: 

• Remove the TRIM PANEL FOR ROOF PILLAR AT REAR  left/right
• Remove the BACKREST SIDE SECTION on left/right
• Reposition left/right rear seat backrest

Version with roller sunblind: 

Release screws (1) on luggage compartment floor (2).

Tightening torque, refer to: 51 46 3AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and expanding rivet (3).

Release door seal (5).

Detach cover (2) towards front with clamp (4) from body.

Installation note: 

Clamp (4) must not be damaged or bent, replace if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

Version with roller sunblind: 

Release and disconnect plug connection (1) at right C-pillar.

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cover (1).

Pay attention to latches (2).

Remove cover (1) and feed out of seat belt (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Release expanding rivet (1).

Slightly raise storage shelf (2) at front and unlock and detach plug connections underneath for speaker.

Remove storage shelf (2) toward the inside and feed out seat belt (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Make sure storage shelf is correctly seated in ventilation grille (1).

Courtesy of BMW OF NORTH AMERICA, INC.

In the case of replacement with appropriate version: 

• Remount left/right SPEAKER 
• Remount the ROLLER SUNBLIND