51 22 300 Removing and installing/replacing weather strip on outside of rear door
Special tools required:
- 00 9 324
- 00 9 325
IMPORTANT:
Weather strip in plastic design cannot be removed without damage.
Observe the PROCEDURE for using special tool 00 9 324.
Refer to: THE "INSTRUCTIONS ON FITTING WINDOW GUIDE SEALS" SERVE AS THE BASIS FOR THIS REPAIR instruction and must be observed without fail.
Observe the PROCEDURE for using special tool 00 9 324.
Refer to: THE "INSTRUCTIONS ON FITTING WINDOW GUIDE SEALS" SERVE AS THE BASIS FOR THIS REPAIR instruction and must be observed without fail.
IMPORTANT:
If reusing the existing window cavity cover strip (1), make sure it is not bent.
Pry out weather strip (1) with special tool 00 9 324 (starting at B-pillar).
In areas that cannot be reached with special tool 00 9 324, carefully pry out weather strip (1) using special tool 00 9 325.
Installation note:
Moisten weather strip (1) before installation with APPROVED LUBRICANT .
Weather strip (1) must lie flush with the door edge at the front and rear.