51 22 280 Removing and installing/replacing door stop on left or right rear door

Necessary preliminary tasks:

Close door windows
Remove the SOUND INSULATION in front section

NOTE: Secure rear door against falling closed.
After disengaging door stop, use suitable means of preventing door from opening past its maximum permissible opening angle (risk of damaging paintwork or bodywork).

Pull out rubber cover (1).

Release screw (3).

Tightening torque, refer to: 51 22 5AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (2).

Tightening torque, refer to: 51 22 3AZ .

Slide out door stop.

Installation note:

Seal (1) must not be damaged.

Remove door stop (1) via aperture (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Following parts of door retainer (3) must not be damaged:

Hinge
Thread

Courtesy of BMW OF NORTH AMERICA, INC.