51 11 158 Replacing base plate for number/license plate

Only use the vehicle-specific number plate baseplate.

The installation of other license plate baseplates is not permissible.

Refer to Service Information License plate attachment at front.

The number plate must be mounted exactly on the number plate baseplate.

If a number plate baseplate is not offered for the corresponding national-market version, the number plate must be mounted directly on the bumper using a drilling template.

Incorrect assembly leads to a malfunction of the sensors of the driver assist systems.

NOTE: Schematic diagram is example of F30 Europe national-market version.

Release screws (1).

Tightening torque, refer to: 51 11 8AZ .

Remove holder (2) towards front.

Courtesy of BMW OF NORTH AMERICA, INC.

If replacing bumper:

Drill out marks (1) on bumper to 10 mm.

Courtesy of BMW OF NORTH AMERICA, INC.

Attach support (2) to bumper and insert screws (1).

Tightening torque, refer to: 51 11 8AZ

Courtesy of BMW OF NORTH AMERICA, INC.