26 11 052 Replacing flexible disc for rear propeller shaft

Necessary preliminary work: 

• Remove the EXHAUST SYSTEM .
• Remove heat shields.

Removal: 

Attention! 

Before removing propeller shaft:

The three-hole flange to the rear axle final drive is balanced with the propeller shaft.

The three-hole flange and propeller shaft must be reassembled in the same position.

Mark three-hole flange (1), flexible disc (2) and propeller shaft (3) in one plane.

Courtesy of BMW OF NORTH AMERICA, INC.

Release propeller shaft from thee-hole flange and center mount.

Loosen screws.

Courtesy of BMW OF NORTH AMERICA, INC.

Slide the propeller shaft towards the rear and remove it from the rear axle differential.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws and remove flexible disc from propeller shaft.

Installation: 

Install the flexible disc on the propeller shaft.

Insert screws and tighten.

Parts:  Replace screws and self-locking nuts.

Tightening torque and angle of rotation, refer to: 26 11 4AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Attention! 

The three-hole flange (1), flexible disc (2) and the propeller shaft (3) must be reassembled in the same, marked positions.

Courtesy of BMW OF NORTH AMERICA, INC.

Install propeller shaft and slide towards rear.

Parts:  Replace screws.

Insert screws and tighten.

Tightening torque and angle of rotation, refer to: 26 11 3AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking: 

• Install heat shields.
• Install the EXHAUST SYSTEM .