33 00... Rear axle: wheel/chassis alignment check must be carried out after the following work
A WHEEL ALIGNMENT CHECK must be carried out after the following work:
- Release the following screw connection:
- Wishbone to rear axle support (2)
- Toe arm on rear axle support (4)
- Toe arm to wheel carrier (4)
- Camber arm on rear axle support (5)
- Camber arm to wheel carrier (5)
- Replacement of following parts:
- Rear axle support (1)
- Wishbone (2)
- Wheel carrier (3)
- Toe arm (4)
- Toe arm (5)
- Ball joint in wheel carrier
- Rubber mount in wheel carrier