51 11 156 Removing and installing front bumper panel

Necessary preliminary tasks: 

• Only F82 GTS:  Remove the front splitter

Remove gasket (1) and release screws (2) beneath it.

Tightening torque, refer to: 51 11 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Feed bumper panel (1) correctly into clamps (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and expanding rivet, if applicable, on bumper panel (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Only F82 GTS: 

Loosen the screw (1) on the front splitter adapter (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on wheel arch cover (2) on left/right.

Lift out wheel arch cover (2) at side.

Installation note: 

Make sure wheel arch cover (2) is in correct position.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on left/right.

Tightening torque, refer to: 51 11 11AZ .

Pull bumper panel (2) forwards a little.

Unlock and detach plug connections on the following components depending on the version.

• Ultrasonic sensors PDC (right wiring harness)
• Pedestrian protection sensor (right and right wiring harness)
• Ultrasonic sensors for parking maneuvering assistant (left/right)

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fog light (left/right)
• ACC sensor (middle)
• Side View Camera (left/right)

If necessary, unlock and detach hose pipe for headlight cleaning system and lay down on top.

Remove bumper panel (2) towards front.

Version with M Aerodynamics package: 

Unfasten mount (1) from catch (2).

Remove bumper trim panel forwards.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Feed support (1) out toward the bottom and insert from the top in the first retaining lug.

After the bumper panel has been removed, push the support (1) down until it is placed on the support.

Courtesy of BMW OF NORTH AMERICA, INC.