REP-TAT-P-3221-01-F30 Removing the track rod end

Preliminary work

Remove the FRONT WHEEL

NOTE: TECHNICAL INFORMATION:
Perform wheel alignment after installation.

NOTE: RISK OF DAMAGE
Component damage caused by striking tools.
Brute force can result in component damage.
Only use those tools intended for the work.

NOTE: Description is for left component only. Procedure on the right side is identical.

Loosen the nut (1), if necessary, counter-hold the Torx socket.
Remove the track rod end (2) from the swivel bearing.

Courtesy of BMW OF NORTH AMERICA, INC.