REP-TAT-P-3221-26-01_F30 Remounting the track rod end on left and right

Remounting the track rod end

NOTE: TECHNICAL INFORMATION:
Perform wheel alignment after installation.

NOTE: Description is for left component only. Procedure on the right side is identical.

Determine dimension (A) to simplify subsequent setting of front axle.
Slacken screw (1).
Unscrew the track rod end, if applicable, counter support the track rod with the open-end spanner.
Screw on the track rod end to this dimension (A).
Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

Track rod end to track rod

32Nm

Courtesy of BMW OF NORTH AMERICA, INC.