65 77 720 Removing and installing (replacing) left B-pillar sensor
Attention!
Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)!
WARNING:
Observe INSTRUCTIONS ON AIRBAG SAFETY REGULATIONS!
Incorrect handling can activate airbag and cause injury.
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
- Disconnect the NEGATIVE BATTERY LEAD and cover
- Remove the TRIM PANEL FOR DOOR POST (bottom)
Removal:
Unfasten plug connection (1) and disconnect.
Release screw (2).
Remove sensor (3).
Installation:
Mount the sensor (3).
Tighten screw (2).
Tightening torque, refer to: 65 77 3AZ .
Connect and lock plug connection (1).
Required reworking:
- Connect the BATTERY EARTH LEAD
- Install the TRIM PANEL FOR DOOR POST (BOTTOM)