61 35 243 Removing and installing (replacing) Smart Opener top sensor line (non-contact rear lid opening)
IMPORTANT:
Read and comply with notes on protection AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION).
Necessary preliminary tasks:
- Remove the REAR BUMPER TRIM
NOTE:
Work shown on the F30 by way of example, deviations in detail are possible in other models.
Unlock associated plug connection (1) on control unit (2) and disconnect.
Installation note:
Make sure plug connection (1) and control unit (2) are correctly fitted.
Make sure connecting line is correctly laid.
IMPORTANT:
Risk of damage, do not kink sensor line!
Feed out associated connecting line in area A.
Release sensor line (1) at clips (2) and remove.
Installation note:
Make sure sensor line (1) is correctly fitted.
Make sure connecting line is correctly laid.
Clips (2) must not be missing or damaged.