66 20 519 Removing and installing/replacing a front center right (inside) ultrasonic transducer (Park Distance Control)
Necessary preliminary tasks:
- Remove the ORNAMENTAL GRILLE FOR BUMPER TRIM (SIDE) AT FRONT
- Only on version Sport Line and M Aerodynamic package Remove the FRONT BUMPER PANEL.
Disconnect plug connection.
Unlock retaining tabs (1) in direction of arrow and pull ultrasound transducer (2) upward out of bracket (3).
Installation note:
Before installation of ultrasonic sensor (2) on wiring harness, clean plug connection!
Retaining hooks (1) of ultrasonic transducer (2) must engage exactly in mountings (3).
Installation note:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).