11 44 001 Removing and installing/replacing oil-to-water heat exchanger (B48B)

Necessary preliminary tasks: 

• Remove FULL-FLOW OIL FILTER .

Removal: 

Release all screws from oil-to-water heat exchanger (1).

Remove oil-to-water heat exchanger (1) from full-flow oil filter.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Replace gaskets (1, 2 and 3).

Courtesy of BMW OF NORTH AMERICA, INC.

Overview of gaskets (1, 2 and 3).

Courtesy of BMW OF NORTH AMERICA, INC.

Clean sealing surface (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Position oil-to-water heat exchanger (1) on full-flow oil filter.

Tighten all screws on oil-to-water heat exchanger (1).

Tightening torque 11 42 9AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install FULL-FLOW OIL FILTER 
• Assemble engine

Courtesy of BMW OF NORTH AMERICA, INC.