11 34 560 Replacing all valve stem seals (B48B)
Special tools required:
- 11 1 480
- 11 6 380
Necessary preliminary work:
- Remove VALVE SPRINGS
Removal:
Disassemble valve stem seal (1) with special tool 11 1 480 .
Installation:
NOTE:
The contact surface (1) must be clean.
NOTE:
Before installing the valve stem seals, the assembly sleeve must
be fitted on the valve stem! Risk of damage
to the sealing lip!
Press on valve stem seal (1) to stop using special tool 11 6 380 in direction of arrow.
Required follow-up work:
- Install VALVE SPRINGS
- Assemble engine