Additional work for camber correction

NOTE: The camber adjustment is performed only with the replacement of the swivel bearing. There are 3 different swivel bearings for this!

IMPORTANT: Changes in axle geometry caused by accidents must under no circumstances be rectified by camber adjustment!

NOTE: The swivel bearing may only be replaced if the camber is outside the specified tolerance after toe adjustment.

Necessary preliminary tasks:

Adjust TOE-IN .
Check camber values; if necessary, replace swivel bearing with over- or under-dimension variant.

NOTE: Standard swivel bearings can only be identified from the BMW part number (1) (cast at the bottom).
See also the applicable BMW spare parts catalogue!

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Camber correction swivel bearings can only be identified from the BMW part number (1) (engraved at the top of the damper mount).
See also the applicable BMW spare parts catalogue!
These camber correction swivel bearings are used to correct the camber values by 30 min. To be used only if the tolerance values are exceeded or undershot!

Version	BMW part number
Standard	6 792 287/288
+ 30'	6 854 197/198
- 30'	6 854 199/200

Courtesy of BMW OF NORTH AMERICA, INC.

After Installation note:

Check directional stability of car; if necessary, repeat TOE-IN adjustment