Replacing rear ride height sensor

Read and comply with NOTES ON ESD PROTECTION (ELECTROSTATIC DISCHARGE) .

Necessary preliminary tasks: 

• Remove CAMBER ARM COVER .

Slacken nut (1).

Tightening torque 37 14 4AZ .

Detach jointed rod (2).

Disconnect plug connection (3).

Unclip cable with holder (4).

Release screw (5).

Tightening torque 37 14 1AZ .

Remove ride height sensor.

Installation note: 

Replace nut (1).

Align holder with corresponding bore hole on rear axle support.

Replace faulty cable clips.

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Release screws (1).

Tightening torque 37 14 2AZ .

Take off ride height sensor from holder (2).

Installation note: 

Sensor lever (3) points towards wheel when installed.

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: 

• Check headlight adjustment, correct if necessary.