11 12 Cylinder Head With Lid
11 12 TIGHTENING TORQUE OVERVIEW
| Bearing journal to cylinder head | ||
| Replace the bearing journal | Tightening torque | 20 Nm |
| Chain tensioner to cylinder head | ||
| 1. Jointing torque | 20 Nm | |
| 2. Angle of rotation | 30° | |
| Cylinder head bolt to timing case cover | ||
| M8x40 | Tightening torque | 20 Nm |
| Cylinder head cover to cylinder head | ||
| M6 | Jointing torque | 8 Nm |
| Tightening torque | 11 Nm | |
| Cylinder head on device | ||
| M10X90x1.5 | tightening torque | 30 Nm |
| Cylinder head to crankcase | ||
| M11x1.5x188 11.9 Fit new cylinder head bolts. |
1. Jointing torque | 30 Nm |
| 2. Angle of rotation | 90° | |
| 3. Angle of rotation | 180° | |
| M11x1.5x188 13.9 Fit new cylinder head bolts. |
1. Jointing torque | 30 Nm |
| 2. Jointing torque | 50 Nm | |
| 3. Angle of rotation | 180° | |
| 4. Angle of rotation | 180° | |
| Cylinder head to special tool 2 361 215 | ||
| Tightening torque | 35 Nm | |
| Flange to assembly jig | ||
| M14X30 | Tightening torque | 135 Nm |
| Front lifting eye on the cylinder head | ||
| M8 x 22 | Tightening torque | 19 Nm |
| Sliding rail to cylinder head | ||
| M6x16 | Tightening torque | 8 Nm |
| Special tool 00 2 320 to special tool 00 2 300 | ||
| M14X95 | Tightening torque | 130 Nm |
| Special tool 2 456 190 to cylinder head | ||
| M6X20 | Tightening torque | 8 Nm |
| Trim strip at the cylinder head | ||
| M7 | 1. Jointing torque | 10 Nm |
| 2. Jointing torque | 16 Nm | |
| 3. tightening torque | 18 Nm | |
| Venting connector/special tool to cylinder head | ||
| M10 | Tightening torque | 18 Nm |