Install the oil vacuum pump
- Check guide sleeves (1)
for damage and replace if necessary.
Parts: Guide sleeves
- Make sure the sealing ring (1)
is installed correctly.
The sealing ring (1) must not be damaged or missing.
- Guide the oil vacuum pump (1) into the drive chain (2).
- Position oil vacuum pump (2) correctly on the guide sleeves.
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Oil vacuum pump to crankcase | ||
| M8 Replace screw. |
1. Joining torque | 15 Nm |
| 2. Angle of rotation | 45° | |
Follow-up work
- Refer to REFITTING SUMP .
- Refer to CONNECTING THE HIGH-VOLTAGE CONNECTION TO THE ELECTRICAL MACHINE .
- Refer to INSTALLING STARTER MOTOR .
- Refer to INSTALLING THE ACOUSTIC COVER FOR THE OIL SUMP .
- Refer to RAISING FRONT AXLE SUPPORT .
- Refer to TOPPING UP THE MOTOR OIL .
- Refer to CONNECTING NEGATIVE BATTERY CABLE (ENGINE COMPARTMENT) .
- Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
- Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
- Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to CHECKING ENGINE OIL LEVEL .