Install the oil vacuum pump

• Check guide sleeves (1)  for damage and replace if necessary.

  Parts:  Guide sleeves

  Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the sealing ring (1)  is installed correctly.

  The sealing ring (1)  must not be damaged or missing.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide the oil vacuum pump (1)  into the drive chain (2). 

Courtesy of BMW OF NORTH AMERICA, INC.

• Position oil vacuum pump (2)  correctly on the guide sleeves.
• Tighten the screws (1). 

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to REFITTING SUMP .
• Refer to CONNECTING THE HIGH-VOLTAGE CONNECTION TO THE ELECTRICAL MACHINE .
• Refer to INSTALLING STARTER MOTOR .
• Refer to INSTALLING THE ACOUSTIC COVER FOR THE OIL SUMP .
• Refer to RAISE FRONT AXLE SUPPORT .
• Refer to TOPPING UP THE MOTOR OIL .
• Refer to CONNECTING NEGATIVE BATTERY CABLE (ENGINE COMPARTMENT) .
• Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
• Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
• Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to CHECKING ENGINE OIL LEVEL .