Remove chain tensioner piston
Preliminary work
- Refer to REMOVING THE RIGHT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING THE COVER IN THE LEFT ENGINE COMPARTMENT .
- Refer to REMOVING TRAILING LINK AT TENSION STRUT TOWER .
- Refer to REMOVING THE SOUND INSULATION ON THE BULKHEAD UPPER PART AT THE CENTER .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING DESIGN COVER .
- Refer to REMOVING CORROSION PROTECTION COVER .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING THE LAMBDA OXYGEN SENSOR .
- Refer to REMOVING THE OXYGEN SENSOR MONITOR .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THE CENTER UNDERBODY PROTECTION .
- Refer to REMOVING COMPLETE EXHAUST SYSTEM .
- Refer to REMOVING CATALYTIC CONVERTER .
- Use this tool: to loosen the chain tensioner piston.
- Loosen the chain tensioner (1) from the bottom using the tool (2).
- Remove the chain tensioner (1) from the top.
- Have a cleaning cloth ready.
A small quantity of engine oil will emerge after the screw connection has been released.
- Make sure no oil penetrates the clutch housing or comes into contact with the exhaust system.