Removing and installing front seat (normal/electric) on the passenger's side from left or right

Necessary preliminary work: 

• Disconnect NEGATIVE BATTERY CABLE .

Installation note: 

• Power lock screws must be replaced and must not be reused
• Power lock screws are mechanical screw locks with trilobular threads

For electrical front seat version: 

Move backrest to full rearward position.

Grip end fitting cover centrally between seat belt strap and cover.

Unclip end fitting cover in direction of arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Install end fitting cover as follows:

1. Insert cover with rear guide in covering.
2. Insert cover in direction of arrow downwards in covering
3. Engage top left of cover in covering.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 72 11 02AZ .

Remove end fitting.

Installation note: 

End fitting is coded against incorrect assembly.

Courtesy of BMW OF NORTH AMERICA, INC.

Move seat to upper back position.

Release and dispose of screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust the seat to the front top.

Release and dispose of screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Lift out front seat.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

• Carpet must not get between seat rails and floor panel in area of attachment points (creaking noises)
• Replace microencapsulated screws
• Insert all screws loose to avoid twisting
• Tighten down all screws to specified torque

Tightening torque 52 10 01AZ .