Removing and installing the front seat on the passenger's side (normal/manual)

Necessary preliminary work: 

• Disconnect NEGATIVE BATTERY CABLE .

Installation note: 

• Power lock screws must be replaced and must not be reused
• Power lock screws are mechanical screw lockings with trilobular threads

Move backrest to full rearward position.

Grip end fitting cover in marked area between cushion and cover.

Unclip end fitting cover in direction of arrow (1).

Feed out end fitting cover (2) in direction of arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Install end fitting cover as follows:

1. Insert cover with front guide in cover
2. Insert cover in direction of arrow downwards in covering
3. Engage top cover in marked area in covering.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque: 72 11 02AZ .

Remove seat belt end fitting.

Installation note: 

End fitting is coded against incorrect assembly.

Courtesy of BMW OF NORTH AMERICA, INC.

Move seat to upper back position.

Release and dispose of screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust the seat to the front top.

Release and dispose of screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Lift out front seat.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

• Carpet must not get between seat rails and floor panel in area of attachment points (creaking noises)
• Replace microencapsulated screws
• Insert all screws loose to avoid twisting
• Tighten down all screws to specified torque

Tightening torque 52 10 01AZ .