Removing and installing/replacing support for rear bumper panel

Necessary preliminary tasks:

Depending on version:

Unscrew screws (1).
Unlock and disconnect plug connection on Smart Opener control unit and bumper aerial

Loosen the latch mechanisms (2) at reinforcement (3).

Remove reinforcement (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Catches (2) must not be damaged or missing.

If necessary, feed out cable.

Unscrew nuts (1).

Tightening torque 51 12 1AZ .

Remove support (2).

Courtesy of BMW OF NORTH AMERICA, INC.