12 36 Control System, Hybrid/Electric Drive
12 36 TIGHTENING TORQUE OVERVIEW
| Battery earth lead to body | ||||
| Observe notes on earth bonding screw connections! M8 |
Tightening torque | 19 Nm | ||
| Battery ground lead to electrical machine electronics | ||||
| Observe notes on earth bonding screw connections! | ||||
| M8x16 | Tightening torque | 19 Nm | ||
| Coolant line to electrical machine electronics | ||||
| M6x25 | Tightening torque | 8 Nm | ||
| High-voltage cable on transmission | ||||
| M6 Tighten screws in crosswise sequence. |
Jointing torque | 3 Nm | ||
| Tightening torque | 8 Nm | |||
| High-voltage cable to electrical machine electronics | ||||
| M6x25 Tighten screws in crosswise sequence. |
Joining torque | 3 Nm | ||
| Tightening torque | 8 Nm | |||
| High-voltage cable to transmission bearing/transmission cross member | ||||
| M6 | Tightening torque | 8 Nm | ||
| High-voltage connector to electric drive unit | ||||
| M8x46 | Tightening torque | 19 Nm | ||
| Holder for electrical machine electronics (ELE) to electrical machine electronics (ELE) | ||||
| M6x30 Replace screws. |
Joining torque | 8 Nm | ||
| Angle of rotation | 90° | |||
| Holder for electrical machine electronics to body | ||||
| M8 | Tightening torque | 22 Nm | ||
| Holder for tension relief | ||||
| M6 | tightening torque | 8 Nm | ||
| Holder for tension relief to electrical machine electronics | ||||
| M6 Replace screws. |
Joining torque | 4 Nm | ||
| Angle of rotation | 45° | |||
| Positive battery cable to electrical machine electronics | ||||
| M8x16 | Tightening torque | 15 Nm | ||
| Potential compensation line on body | ||||
| M8 | Tightening torque | 19 Nm | ||
| Observe notes on earth bonding screw connections. | ||||
| Potential equalization line to electrical machine electronics | ||||
| Observe notes on earth bonding screw connections! | ||||
| M8x16 | Tightening torque | 19 Nm | ||