51 34 160 Removing and installing/replacing housing cover on inner left or right door window frame

Necessary preliminary tasks: 

• Open side window
• Remove REAR DOOR TRIM PANEL 

Version with roller sunblind: 

• Remove ROLLER SUNBLIND  from fixed side window

Version with roller sunblind: 

Press hook (1) down toward the inside using your thumb until the locking tab (2) becomes visible through the distortion.

In this position pull off hook (1) towards the outside.

Installation note: 

Locking tab (2) and mounting T-piece on hook (1) must not be damaged or missing.

Fig 1: Pressing Door Window Frame Hook

Courtesy of BMW OF NORTH AMERICA, INC.

Version with roller sunblind: 

Installation note: 

Retaining clip (1) must not be bent or damaged.

Fig 2: Identifying Door Window Frame Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Pry off weather strip (1) towards the top.

Fig 3: Identifying Weather Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Release cover (1) at clamp (2).

Unclip remaining cover (1) in direction of arrow, or pry it out and remove it.

Fig 4: Removing Door Window Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Feed cover on window frame (2) neatly into the gap of the rubber window seal (1).

Fig 5: Locating Window Frame And Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

The following parts of cover (1) must not be missing or damaged:

1. 2 Connection point
2. 3 Clamps (mount on rear door if necessary)
3. 4 Guides
   Fig 6: Identifying Window Frame Clamps And Guide

   Courtesy of BMW OF NORTH AMERICA, INC.