51 41 019 Removing and installing or replacing door handle on door trim, front left or right
WARNING: This page does not describe the selected car, but rather 41 other vehicles, including the 2018 BMW 320i xDrive, 2018 BMW 320i, 2017 BMW 320i xDrive, 2017 BMW 320i, and 2016 BMW ActiveHybrid 3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove front DOOR TRIM PANEL
NOTE:
Door handle is welded to door trim panel only on initial installation. The door handle is screw-connected on second installation. If necessary, release screws instead of welding spots.
IMPORTANT:
Risk of damage!
To avoid damaging the contact surface, only drill down to door trim panel area (3).
To avoid damaging the contact surface, only drill down to door trim panel area (3).
Drill out welding spots (1 and 2) on door trim panel (3) with drill 8 mm dia.
Remove weld residuals on door trim panel (3) and, if necessary, on door handle with scalpel (for heavy duty use).
Replacement:
Saw off welding pins (1) along moulding (2).
Insert door handle in door trim panel.
Installation note:
Welding pins (1) are not to protrude over door trim panel.
Installation note:
Secure door handle with repair screws (1).
Tightening torque 51 41 3AZ .