51 11 060 Removing and installing/replacing support for front lower bumper panel

WARNING: This page does not describe the selected car, but rather 41 other vehicles, including the 2018 BMW 320i xDrive, 2018 BMW 320i, 2017 BMW 320i xDrive, 2017 BMW 320i, and 2016 BMW ActiveHybrid 3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front BUMPER PANEL

F20/F21 only:

Remove FRONT UNDERBODY PROTECTION in the working area

Version with air duct:

Unscrew bolts (1) and expanding rivet (2).

Remove air duct (3).

NOTE: Schematic diagram shows the right side. Perform repair work on the left side in the same manner.

Fig 1: Identifying Air Duct, Rivet And Bolts

G10096892

Courtesy of BMW OF NORTH AMERICA, INC.

Version with ACC:

Release screws/blind rivet (1).

Installation note:

Blind rivet nuts* and associated screws* are used as repair solution for defective threads or installed blind rivet.

* Sourcing reference: BMW Parts Department.

Adhere to the NOTES on mounting blind rivet nuts.

Fig 2: Identifying Bumper Panel Blind Rivet

G10096890

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 51 11 10AZ .

Remove support (2) in direction of arrow.

Fig 3: Removing Bumper Panel Support

G06885313

Courtesy of BMW OF NORTH AMERICA, INC.

In the case of replacement ACC version:

Drill out blind rivets (1).

Modify holder (2) with ACC sensor.

Adjust ACC SENSOR .

Fig 4: Identifying ACC Sensor Holder

G10096895

Courtesy of BMW OF NORTH AMERICA, INC.