31 12 050 Removing and installing/replacing left or right trailing link

WARNING: This page does not describe the selected car, but rather 41 other vehicles, including the 2018 BMW 320i xDrive, 2018 BMW 320i, 2017 BMW 320i xDrive, 2017 BMW 320i, and 2016 BMW ActiveHybrid 3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT WHEEL .

Release screws (1).

Remove cover (2).

Fig 1: Identifying Temperature Sensor Cover And Screw

G10095349

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1), if necessary, grip at inner Torx socket.

Tightening torque: 31 12 2AZ .

Installation note:

Replace self-locking nut.

Keep trailing link to swivel bearing connection clean and free from oil and grease.

Fig 2: Identifying Slacken Nut

G10095351

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque: 31 12 1AZ .

Remove tension strut.

Installation note:

Replace screw (1).

Tighten down screw connection in NORMAL POSITION .

Fig 3: Identifying Screw

G10095350

Courtesy of BMW OF NORTH AMERICA, INC.