22 11 001 Replacing right engine mount (N20)

Necessary preliminary tasks: 

• Remove right ENGINE SUPPORT ARM .

Release screws (1).

Tightening torque 22 11 1AZ .

Remove engine mount.

Fig 1: Identifying Engine Mount Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Rubber part (1) of engine mount must point to center of vehicle.

Engine mount identification:

• Right engine mount
  • Even component number
• Left engine mount
  • Odd component number
    Fig 2: Identifying Engine Mount Rubber Part

    Courtesy of BMW OF NORTH AMERICA, INC.